④Press the HOLD(▲) or
PRINT(▼) key to have number up
or down. To enter next digit, press
the SAMPLE(▶) key.
⑤Press the SET key, the display
shows “H00000”.
⑥Press the HOLD(▲) or
PRINT(▼) key to have
number up or down. To enter
next digit, press the
SAMPLE(▶) key.
⑦ Press the SET key, the display shows “CL ON”..
⑧ If you set up LOW/HIGH limit wrong, “CL Err” will be shown on the display. Then you have to set it up again .
For example) LOW=00100, HIGH=00090 or LOW=00100, HIGH=00100
⑨ Press the MODE key to go to weighing mode.
⑩ Suppose that the High limit of 200 and the Low limit of 80 are set up. In this condition, OK lamp is lighted on if the
weight is 120, HI lamp is lighted on if the weight is 220 and if the weight is 60, LO lamp is lighted on. It beeps as fixed
on User Setup Mode. (Refer to Setup Mode Table on page 17)
To Next Page
Loading...
