Need help?Do you have a question about the CAS ED and is the answer not in the manual?
Guide to entering calibration mode and navigating through various calibration sub-modes.
Procedure for span calibration, involving loading weights and using tare key for setting points.
Procedure for inputting and saving the gravitational acceleration value for calibration.
Setting calibration factors for unit, capacity, decimal point, division, and dual interval.
Procedure for percentage calibration using specific weight loads and key inputs.
Procedure for calibrating battery voltage by adjusting jumper settings on the main PCB.
Detailed list of components and specifications for the Main PCB assembly.
List of components and their specifications for the Key PCB assembly.
To Next Page
General
