13
Press the SET key, the display ⑦ shows “WL ON”.
⑧ If you set up LOW/HIGH limit wrong, “WL ERR” will be shown on the display. Then you have to set it up
again. For example) LOW=10kg HIGH=9kg High limit is lower than Low limit.
⑨ Press the MODE key three times to go to weighing mode.
⑩ Suppose that the High limit of 7kg and the Low limit of 3kg are set up. In this condition, OK lamp is lighted on if
the weight is 4kg, HI lamp is lighted on if the weight is 8kg and if the weight is 2kg, LO lamp is lighted on. It beeps as
fixed on User Setup Mode. (Refer to Setup Mode Table on page 18)
7-2. Counting comparison function
①Press the MODE key until the
display shows “CL OFF” It
means the counting comparison
function is deactivated.
②Press the HOLD(▲) key to
activate this function, the display
shows “CL ON”.
③Press the SET key, the display
shows “L00000”.
To Next Page
Loading...
