CAS PDS - Page 19

20
SELECT THE RANGE of PASSWORD TO BE APPLIED
KEY FUNCTION DISPLAY VAL. DESCRIPTION
Select 0 or 1 0 Not set
ENTER
Save &
Go to F10
F09
1 Set the range of password
F09 = 1 (Set the range of password)
ENTER
PASS
Display
_ _ _0
ENTER Input password
Good
Using the key,
Input the password4 digits
Select 0 or 1
PASS - 0
PASS - 1
Not set the Enter key password
Set the Enter key password
UNIT Save & Exit Save & go to Normal Mode
Note 1. If the password is not correct, the message of “AgAIn” is displayed.
If you failed three times continuously, the message of "Fail" is displayed
and exit this mode automatically.
SELECT THE CHANGE OF PASSWORD
KEY FUNCTION DISPLAY VAL. DESCRIPTION
Select 0 or 1 0 Not change the password
ENTER
Save & go to
Normal mode
F10
1 Change the password
F10 = 1 (Change the password)
ENTER
PASS
Display
_ _ _ 0
ENTER Input password
Good
Using the key,
Input the password 4 digits
PASS 1
ENTER
_ _ _ 0
Input the new password
PASS 2
ENTER
_ _ _ 0
Input the new password again
Note 1. The password when the product is put out is 1234.
If PASS2 is not same to PASS1, it’s displayed Err-32 and then return to
input mode of PASS1.