CAS PD-I User Manual

One Blue Hill Plaza, 16
th
Floor, PO Box 1546
Pearl River, NY 10965
1-800-PC-AMERICA, 1-800-722-6374
(Voice) 845-920-0800 (Fax) 845-920-0880
1 | P a g e
Setting up the CAS PD-I
This document contains step-by-step instructions for setting up the CAS PD-I to work with CRE.
To connect the CAS PD-I to your computer, you need the following cable:
The CAS Part Number is: JPDB SHARP RS232 7880-PD0-4134 or IBM 7880-PD0-4128

CAS PD-I Specifications

General

Brand	CAS
Model	PD-I
Category	Scales
Language	English

Summary

Setting up the CAS PD-I

Connecting the CAS PD-I to Your Computer

Information about connecting the CAS PD-I scale to a computer and the required cable.

Calibrating the CAS PD-I

Remove Calibration Bolt and Plate

Steps to remove the calibration bolt and plate before starting calibration.

Initiate Calibration Mode

Pressing and holding a switch, then powering on the scale to enter calibration.

Set Scale Capacity

Placing the platter upside down and using switches to select the scale's weight capacity.

Set Unit and Interface Type

Configuring the scale's unit of measurement (kg/lb) and interface type.

Finalize Calibration Test

Placing the platter correctly, powering on, and verifying the 0.00 test cycle display.

Reassemble Calibration Components

Removing the platter and replacing the calibration bolt and plate to complete setup.

Connecting the CAS PD-I to Your Computer

Locate and Connect Serial Port

Finding the computer's serial port and plugging in the scale's cable.

Setting Up the CAS PD-I to Work with CRE

CRE Initial Setup and Hardware Tab

Navigating CRE to the Setup Screen and selecting the Hardware tab for scale configuration.

Configure COM Port and Scale Type

Selecting the correct COM port and primary scale type (CAS PD-I) within CRE.

Set Weight Formatting and Activate

Configuring weight formatting, activating the scale feature, and updating CRE settings.