CAS PDS - COM1(RS-232) USE (D02); COM1 TRANSMISSION METHOD (D03)

22
DEVICE ID
KEY FUNCTION DISPLAY VAL. DESCRIPTION
01:ID=0, 99:ID=99
00 If you use a system, you can iden-
~ tity each indicator by this device ID
Increase or
decrease
set value
99 If you set it to 00, there is no trans-
mission response cause 00 means
ENTER
Save &
Go to d02
d01
that is no device
UNIT Save & Exit Save & go to Normal Mode
COM1(RS-232) USE
KEY FUNCTION DISPLAY VAL. DESCRIPTION
0 Do not use COM1
1 CAS Protocol(22 bytes)
Select 0 ~ 4
2 Limit Protocol(22 bytes)
3 Printer Mode
ENTER
Save &
Go to d03
d02
4 ECR Mode
UNIT Save & Exit Save & go to Normal Mode
COM1 TRANSMISSION METHOD
KEY FUNCTION DISPLAY VAL. DESCRIPTION
0 No data output
Transmit in stable & unstable
Select 0 ~ 3
1
condition
2 Transmit only in stable condition
ENTER
Save &
Go to d04
d03
3 Command mode
UNIT Save & Exit Save & go to Normal Mode
Ref) Command mode can’t apply com1, com2 at once.