13
④ If you select "P_10" as a
sample unit, then please
put 10 sample units on the
scale. Then press key
to set sample units.
⑤ Put all of commodities you
wish to count, and then
check the number of pieces
on display.
⑥ Remove all of
commodities from the scale.
■ Counting with Tare
① Press key twice to go
to sample unit selection mode.
"PCS" is shown on the display,
then press key to select
the number of sample unit.
② Put the container on the
scale and press key to
set weight of tare.You can
select 10, 20, 30, 40, 50,
60, 70, 80, 90, 100,200,
300,400, or 500 as a sample
unit, by pressing key.
③ If the number of selected
sample unit is 20, please
put 20 sample units on the
scale.Then press key
to set unit weight.
④ Put all of commodities you
wish to count, and then
count the number on display.
⑤ Remove all of commodities
from the scale.
⑥ Remove the tare from
the platter.
To Next Page
Loading...
