20
7-6. How to Connect RS-232C Wire
- SERIAL INTERFACE
8. How to Set Auto Power Off
Auto-Power off function is to automatically power off as time is set.
This function is helpful to save battery, which is not in use.
The following is the setting procedure of Auto-power off.
① When the scale is turned
off press key, holding
key. Then press the key,
one more time. You will see
the “AP-XX”.(If you have set
this before, display will show
previous value.)
② Press the key until the
display shows the "AP-X0"
that you wish to take.
(Refer to TABLE 1.)
③ Press the key twice,
and then the scale saves
what you programmed and
shows all the segments,
counting up "0" to "9".
To Next Page
Loading...
