CAS SW-1W - Print Mode Change

1
4
⑧ When you try to set the
number of sample unit at the
③ stage the display may show
"LACK" message shortly.
The result of counting may be
incorrect in the following cases.
a. unit weight ≤1/2 e *
b. weight loaded ≤2% of
maximum weighing capacity.
⑦ Press "Tare" key to exit
from tare function.
7. How to Use Print(Option)
7-1. Mode Change
You can use print out function. Print Out Mode has total 5 stage.
Each Stage is “NOSEND, K-SEND, S-SEND, U-SEND, C-SEND”
① When the scale is turned
off press key, holding
key. Then you will see the
“U SEt”.
② If you press the key
one more time, You will see
the “noSnd” or before state
(“noSnd” mean ‘No Send’ and
This stage cannot print out.)
③ Press the key,
You can change the print
mode. Mode order is NoSnd
->K-Snd->S-Snd->U-Snd->
C-Snd.