15
7-2. K-Send
■ Mode Setting
This Print Mode is ‘Command Mode’. First of all, You must scale’s mode setting.
① If you see “K-Snd” on
display, Press the key,
You can save this mode and
you will see the Auto Power
mode(“AP-oF”).
② If you see “AP-XX” on
display, Press the key one
more time, you can save
Auto Power’s current state.
③ You will see the firmware
version and all the segments
and count up “0” to “9”.
■ Print Operation
① Place a commodity on the
platter, then the display will
show the weight of the
commodity.
② If you press the key,
You can see the “SUM”
message and Current weight
and then you can send the
weight to the printer.
③ Place a another
commodity on the platter.
To Next Page
Loading...
