SECTION 58 - DRIVELINES - CHAPTER 3
58-14
CUTTER BAR
Disassembly
1. Remove the disc, rock guard and skid shoe from
the module to be removed in order to gain access
to the tie bolts. Loosen the tie bolts by installing
the holding tools #FNH01221-2, 1, on one end of
each tie bolt. Use wrench #FNH01221-3, 2, with a
3/4 inch breaker bar to loosen the front and rear
nuts alternately a flat at a time until nuts can be
turned freely by hand.
NOTICE: Do not loosen one nut completely as this
will cause cutter bar to bow and may cause failure of
the opposite tie bolt.
NOTICE: The tie bolts will be easier to loosen if the
disc mower is mounted to a tractor. If not mounted,
it may be necessary to secure the cutter bar in some
manner prior to attempting to loosen the tie bolts, to
prevent tipping the mower off its jackstand.
2. Slide the cutter bar apart far enough to allow
removal of the disc module, 1.
27
28
To Next Page
Loading...
