Case IH MD72 - Page 67

SECTION 58 - DRIVELINES - CHAPTER 1
58-7
SHIELDING
Disassembly
1. Pry out the shield clip, 1, using a flat bladed
screwdriver.
2. Use a small flat bladed screwdriver or pick to pry
the shield bearings, 1, upwards out of the notches
in the shield bell, and then pull them out of the
shield.
3. Slide the shield tube, 1, and bell, 2, off of the PTO
shaft.
600-3-17
1
15
600-3-18
1
16
600-3-19
1
2
3
17