SECTION 21 - TRANSMISSION 83
Refit the temperature sender and tighten to a torque
of 20-27 Nm.
Ensure the 4 O-rings are in place then refit the con-
trol valve assembly, tighten the 4 cap screws to a
torque of 6.8 to 8.5 Nm. Refit the 4 plastic caps to the
capscrew holes.
NOTE: the valve can only be fitted one way round as
it is located by a small dowel pin.
Refit the strainer, the spacer, the O-ring and the cov-
er plate. Then tighten the two screws to a torque of
18-31 Nm.
Refit the drain plug and the O-ring assembly.
Tighten to a torque of 34-54 Nm.
To Next Page
Loading...
