84 SECTION 21 - TRANSMISSION
Refit the 4th gear lock out screw, (when this feature
is not required a shorter blanking screw is fitted). On
some applications an additional sealing plug may be
fitted.
Apply a bead of RTV joint compound (Loctite 5900)
to the gear case.
Refit the gear lever assembly and tighten the three
bolts to a torque of 16-24 Nm.
Refit the filter housing and gasket. Tighten the two
bolts to a torque of 45-64 Nm.
NOTE: do not use sealant on this gasket as it is
graphite coated.
To Next Page
Loading...
