Case 590SN - Snap-to-Connect (STC) Hydraulic Connectors

INTRODUCTION
4.InstallthenewO-Ring(A)inthegroovebehind
theBack-UpRing(B)andinspecttoensurethat
theO-RingandBack-Upringaresecureinthe
groove.LubricatetheO-Ringwithcleanhydraulic
uidCASEAKCELANEXPLORE™FLUID.
5.IftheLatchRing(C)isdamaged,carefullyremove
theLatchRingwithoutdamagingtheinteriorsur-
facesoftheconnector.
6.CarefullyinserttheLatchRingintheLatchRing
groove.ThenewLatchRingshouldbeabletoro-
tateinthegroove.
7.Inspectandreinstalltheconnector.Followthein-
stallation/connectionstepsforinstallation.
4819455820/10/2017
67