EasyManua.ls Logo

Case 885B VHP - Engine Cooling System

Case 885B VHP
208 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS
6-22

Cooling System Capacity ............................................................................................................ 32,0 liters (8.4 US gal)
Radiator coolant uid level check ....................................................................................... Every 10 hours of operation
Cooling system drain, ush, and rell interval ........................................... Every 2000 hours of operation or each year
Thermostat
Starts to open ............................................................................................................................................. 82°C (180°F)
Completely open ......................................................................................................................................... 95°C (202°F)
Expansion tank cap ................................................................................................................. 103,4 kPa, 1 bar (15 psi)
Coolant Mixture
ENGINE COOLING SYSTEM
A mixture of 50% AKCELA PREMIUM ANTI FREEZE and
50% water must be used in this machine. This mixture is
used if the lowest ambient temperature is above -37°C
(-34°F). If the ambient temperature is lower, adjust the
mixture to 60% AKCELA PREMIUM ANTI FREEZE and
40% water. It is recommended that AKCELA PREMIUM
ANTI FREEZE and water be used in your machine all
year.
NOTE: After you ll the cooling system, mix the AKCELA
PREMIUM ANTI FREEZE and water completely by run-
ning the engine at operating temperature for approxima-
tely ve minutes. This procedure must be done when the
machine is in temperatures below 0°C (32°F).
WARNING: Hot coolant can spray out if ex-
pansion tank cap is removed. To remove ex-
pansion tank cap: Let system cool, turn to rst
notch, then wait until all pressure is released.
Scalding can result from fast removal of ex-
pansion tank cap. Check and service engine
cooling system according to maintenance ins-
tructions.
1
2
3
1. EXPANSION TANK CAP
2. COOLING WATER LEVEL GAUGE
REGISTER FOR AIR BLEED3.

Table of Contents

Other manuals for Case 885B VHP

Related product manuals