4 - 8
DIAGNOSTIC - SELECTION
CASE TRAINING CENTER
AUGUST 2000
Machine history
1. Screen HR1
2. Screen HR2
3. Screen HR3
4. Screen HR4, operating time of the various P1 pressures
HR MODE II H T 0000 HR
1
ENG 0000 HR S 0000 HR
WRK 0000 HR PU 0000 HR
U 0000 HR BRK 0000 HR
ENG: Hourmeter
WRK: Length of time that excavator has been
used (with attachment or travel operating)
U: Length of time that attachment has been
used
T Length of time that travel has been used
S: Length of time that swing has been used
PU: Length of time that power boost has been
used
BRK: Length of time that hammer has been used
HR MODE II H A 0000 HR
2
H 0000 HR WT 0000 °C
S 0000 HR OT 0000 °C
L 0000 HR FT 0000 °C
H Length of time excavator was used in H
S: Length of time excavator was used in S
L: Length of time excavator was used in L
A Length of time excavator was used in AUTO
WT: Maximum engine temperature
OT: Hydraulic oil maximum temperature
FT: Fuel maximum temperature
HR MODE II H 4 0000
3
1 0000 5 0000
2 0000 6 0000
3 0000 7 0000
1: Length of time the electronic control box
was used
2: Length of time slow travel was used
3: Length of time fast travel was used
4: Length of time travel alone was used
5: Maintenance intervals
6: Not used
7: Not used
HR MODE II H 4 0000
4
1 0000 5 0000
2 0000 6 0000
3 0000 7 0000
1: 100 bar (10 MPa) or less
2: Between 100 bar (10 MPa) and 150 bar
(15 MPa)
3: Between 150 bar (15 MPa) and 200 bar
(20 MPa)
4: Between 200 bar (20 MPa) and 250 bar
(25 MPa)
5: Between 250 bar (25 MPa) and 300 bar
(30 MPa)
6: Between 300 bar (30 MPa) and 350 bar
(35 MPa)
7: 350 bar (35 MPa) or above
To Next Page
Loading...
