Case DV201 - Servicing Instructions; Hourmeter

1 - GENERAL INSTRUCTIONS
15
SERVICING INTRUCTIONS
Respect the maintenance intervals by checking the
hourmeter daily. Before carrying out any service work,
park the machine on flat, firm ground, away from any
obstacles. Unless otherwise specified, all service work
should be carried out with the engine shut down and
the starter switch key removed. It is preferable to wait
for all circuits to cool down before beginning work. Wear
suitable clothing and use appropriate safety equipment.
Clean all grease points before greasing. Clean around
plugs and orifices before adding fluid. No dirt or foreign
matter must be allowed to enter components or circuits.
When performing maintenance work on the machine,
place a “Do not operate” label on the front console.
Never leave the operator’s compartment while the
engine is running.
Any modification to this machine without prior authori-
zation could cause serious injury. Do not make any
modifications without authorization. Consult your
Dealer.
IMPORTANT: If you use your machine in particularly
harsh conditions (dusty or corrosive atmosphere), the
servicing intervals should be reduced accordingly.
Take particular care to replace all filters regularly.
Clean filters mean longer engine running life.
Do not pour used oil onto the ground or down a drain.
Stock the oil in sealed containers for collection by a
company which recycles or disposes of it.
HOURMETER
Located under the engine hood, near the battery, the
hourmeter enables servicing operations to be scheduled.
It works in the same way as a clock when the engine is
running.
Servicing intervals are carefully calculated to guarantee
safe and efficient machine operation.
Be sure to carry out all the servicing operations properly,
as defined in this manual.
WARNING
Be sure all the service operations in this section
are carried out punctually at the intervals given, in
order to ensure optimum performance levels and
maximum safety when using the machine.
There is a risk of serious injury if maintenance or
repairs are not performed correctly. If you do not
understand the maintenance procedures, consult
your Dealer.
!
!
WARNING
Before carrying out any service work, proceed as
follows:
- Park the machine on hard, flat ground.
- Shut down the engine and remove the starter
switch key.
- Put blocks under the drums to prevent the
machine from moving.
- Block the machine articulation.
! !
CD02F009
1