1
CONTENT
1 GENERAL INSTRUCTIONS 3
INTRODUCTION 3
SAFETY INSTRUCTIONS 4
ENVIRONMENTAL MEASURES AND HEALTH PRECAUTIONS 7
PRODUCT IDENTIFICATION 9
TORQUES SPECIFICATIONS 12
SERVICING INSTRUCTIONS 15
HOURMETER 15
SERVICING INTERVAL 16
FLUIDS AND LUBRICANTS 18
FLUIDS AND LUBRICANT CAPACITES AND SPECIFICATIONS 21
2 DESCRIPTION OF THE MACHINE 23
3 THE ENGINE 37
REMOVAL OF THE ENGINE FROM THE MACHINE WITH THE TRAVEL PUMP 39
4 DRUM 69
REMOVAL OF THE HYDRAULIC MOTOR OF VIBRATION 69
REMOVAL OF THE HYDRAULIC MOTOR OF TRAVEL 81
REPLACEMENT OF RUBBERIZED METAL PIECES ON THE DRUM 107
REPLACEMENT OF THE SEAL ON THE DAMPING PLATE ON THE MACHINE 139
REMOVAL OF DRUMS FROM THE FRAME OF THE MACHINE 153
REMOVAL OF THE ECCENTRIC FROM THE DRUM 195
INSTALLATION OF THE DRUM ON THE FRAME OF THE MACHINE 207
5 STEERING JOINT 217
REMOVAL OF THE STEERING JOINT FROM THE MACHINE 217
REMOVAL OF THE STEERING JOINT 231
INSTALLATION OF THE STEERING JOINT 241
6 HYDRAULICS 253
REMOVAL OF THE TRAVEL PUMP AND THE CLUTCH 253
REMOVAL OF THE PUMPS OF VIBRATION AND OF STEERING 271
REMOVAL OF THE OIL COOLER 281
REMOVAL OF STEERING HYDRAULIC MOTOR FROM THE MACHINE 295
REMOVAL OF THE STEERING HYDRAULIC MOTOR 303
INSTALLATION OF THE STEERING HYDRAULIC MOTOR 309
REMOVAL OF THE SERVOSTEERING 313
REMOVAL OF THE HYDRAULIC TANK 319
REPLACEMENT OF THE ELECTROMAGNET VALVE OF VIBRATION ON THE MACHINE 331
REMOVAL OF THE HYDRAULIC LOOP FILTER 335
REPLACEMENT OF FILTER CARTRIDGE AND OIL 339
DISASSEMBLY OF SUCTION STRAINER 345
SCHEMATICS OF THE HYDRAULIC LOOP 349
HYDRAULIC OF DRIVE 352
LINEAR VALVES 354
HYDRAULIC OF VIBRATION 355
HYDRAULIC OF STEERING 358
FLUSHING AND DRAIN 360
7 CONTROL OF GAS 361
REMOVAL OF BOWDEN CABLE OF GAS CONTROL 361
REMOVAL OF TRAVEL LEVER ON THE CONTROL PANEL 365
REMOVAL OF TRAVEL PULL ROD 373
8 PLATFORM 383
REMOVAL OF THE PLATFORM 383
REMOVAL OF RUBBERIZED METAL PIECES OF THE PLATFORM 389
DV201 - DV202 - DV204
Vibratory Rollers
To Next Page
Loading...
