1 - GENERAL INSTRUCTIONS
4
SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS
The following safety instructions must be observed by
ALL personnel repairing the machine.
1. Repairs may be carried out by skilled, trained and
experienced personnel only.
2. When performing repairs, always use our service
manual. Special instructions for the assembly work
are given in individual chapters of this manual.
3. Before putting the machine into operation familiar-
ize yourselves with the machine controls as
explained in the “Operator’s Manual” and make
sure that you are completely familiar with the
machine.
4. Do not use the machine if you do not fully under-
stand all controls and until this know how the
machine works.
5. Familiarize yourself with the area where you will
work.
6. Do not carry out any redesign work or modifica-
tions on the machine because you could compro-
mise the safety of the equipment.
7. Original parts and accessories have been
designed especially for this machine.
8. Installation and use of spare parts not supplied by
the manufacturer of the machine or not authorized
by them can have negative effects on operational
characteristics and safe operation of the machine.
REPAIRING AND INSPECTING THE MACHINE
1. Wear working clothes and boots.
2. Use gloves when handling oils, fuel or coolant.
3. Protect your eyes with a full face shield when han-
dling the battery.
4. Place the equipment on a flat and firm surface
before starting repair. Secure the machine to pre-
vent spontaneous movement.
5. Secure the frame of the machine and the drum to
prevent rotation using a locking pin and a draw bar.
6. Before starting work remove the starter switch key,
disconnect the batteries and let hot parts cool
down.
7. Attach a "Do not operate" warning note to the
steering wheel and leave it there for the duration of
the service work.
8. Wash the equipment thoroughly. If you use steam,
do not expose electrical components and insula-
tion directly to the steam, otherwise cover them
beforehand.
9. Keep all parts absolutely clean when dismantling,
mounting, and servicing each assembly. Protect
removed parts from getting soiled.
10. Clean the surface of dismantled parts and do the
necessary to ensure adequately dust-free working
conditions and a suitable storage area.
11. Be careful when handling cleaning agents. Do not
use fuel or other easy inflammable materials for
cleaning.
12. Dry the cleaned parts and immediately cover with
anti-corrosive protective oil, never install corroded
parts.
13. Tools, hoists, safety equipment on chains, and
other additional items must be serviceable and in
good condition.
14. Use hoists and fasteners (ropes, chains) that have
sufficient lifting capacity and are in good condition.
15. Make sure that there is enough fresh air supply
when starting up the equipment in an enclosed
area.
To Next Page
Loading...
