SECTION 1 -- SAFETY FEATURES AND VEHICLE OPTIONAL SAFETY
1-- 9
DAILY MAINTENANCE
Carry out maintenance as required by the manufac-
turer – Refer to Section 4: “Lubrication and mainten-
ance”.
In order to maintain the machine, we advise you to
have your machine regularly checked by your dealer.
Before starting the machine, check daily the fluid
levels of:
-- Engine oil
-- Hydraulic reservoir oil
-- Transmission oil
-- Fuel
-- Cooling liquid
-- B r a k e o i l
TYRES
Familiarise yourself with the machine and the ground
on which the machine is to be operated.
Ensure tyres are adapted to the nature of the ground.
Consult your dealer.
Mounting tyres inflated with foam should be avoided
at all times. These are not accepted by the manufac-
turer without his specific authorisation.
OPERATING CONDITIONS
We advise to fit the machine with a fire extinguisher.
Consult your dealer in case of doubt.
Take into account climatic and atmospheric condi-
tions of any site you are working on.
Do not operate the machine in hazardous atmos-
pheres, for which the machine is not designed.
For use in protected areas, example: oil refinery,
explosive atmosphere, mining special equipment
must be available (consult your dealer).
Protection against frost – Refer to Section 4:
“Lubrication and Maintenance”.
Optional exterior lighting is available, consult your
dealer.
VEHICLE CHARACTERISTICS
For your safety and safety of bystanders, do not alter
either the structure or the different components of the
machine by yourself.
PREPARING T O DRIVE
Wear clothes suited for driving the machine, avoid
loose or hanging clothes (neckties, etc.) and jewel-
lery.
Do not drive with wet hands or shoes, or soiled with
greasy substances.
The operators must be fully acquainted with the loca-
tion and operation of all controls, instruments and
capabilities of the vehicle.
IMPORTANT: Prior to driving the Telehandler, with
the engine running, turn the steering wheel, lock to
lock. This ensures all hydraulic circuits are fully
charged prior to operation.
Before driving the machine, check daily the functions
of:
-- Steering
-- Brakes
-- Hydraulic services
-- Electric system
NOTE: It is recommended that all instruments be
checked for correct function, immediately after start-
ing the engine, when the engine has warmed up and
at frequent intervals when the machine is in use.
Should a fault occur, the engine should be stopped.
And any malfunction investigated and rectified within
the shortest possible delay.
For better comfort, adjust the driver’s seat to your
own convenience and adopt the correct position in
the driver’s cab.
To Next Page
Loading...
