Casella HB4056-01 dBadge2 User Manual

May 2015 Page 21 of 51
7.3 Contrast
7.4 Display Timeout
7.5 Selecting Dosimeter Setups
dBadge2 has up to 3 simultaneous dosimeters, D1 D2 and D3 which only determine what is
displayed on screen and not what is calculated and saved to memory for later download and
analysis. The primary Dosimeter, D1, cannot be disabled and may be configured to display
any one of six configurations by choosing from the alternatives as shown below and explained
in more detail in Section 7.6. There is also a fully custom configurable option which is
achieved using Casella Insight data management software.
Additional dosimeters D2 and D3 may be selected to display any of the other available
configurations.
Note that visual alarms are based only on D1 values.
Set Hour: ‘R’ to accept or ‘L’ to scroll
Set Minute: ‘R’ to accept or ‘L’ to scroll
Set Day: ‘R’ to accept or ‘L’ to scroll
Set Month: ‘R’ to accept or ‘L’ to scroll
Set Year: ‘R’ to accept or ‘L’ to scroll
Set the display contrast by pressing ‘R’ to
accept and ‘L’ to choose from 6 brightness
levels
The display can be left permanently on (which
will reduce battery life) or will timeout after the
selected interval of 5, 10, 20 seconds, 1 or 5
minutes

Casella HB4056-01 dBadge2 Specifications

General

Brand	Casella
Model	HB4056-01 dBadge2
Category	Measuring Instruments
Language	English