May 2015 Page 37 of 51
Motion Sensor Motion sensor detects any non- stationary motion.
The index represents the percentage of
measurement time that movement is detected during
an entire measurement run.
Audio events recording (Plus & Pro) 15 second (including 3 second pre-trigger) level
triggered sources include LAF, LAS, LCPk, LZPk.
8kHz sampling rate, 16 bit compressed wav format.
Audio Notes (Plus and Pro) An audio note up to 15 seconds duration for each
measurement run.
Recorded Data Parameters The dBadge2 simultaneously records and computes
ALL noise data and for EVERY measurement run.
The comprehensive set of data containing all of the
below parameters is available to view and analyse
within the Casella Insight PC application. The
Dosimeter Setups D1, D2 and D3 simply define
which parameters are displayed on the instrument
itself but all values are automatically stored in the
memory of the dBadge2 for download.
LAvg
TWA (8hr) Projected TWA 8hr
Dose% Proj Dose %
LAEQ LCEQ LAIEQ
LEPd / LEX, 8h Proj LEPd/LEX, 8h
LAPk + Time LCPk + Time LZPk + Time
Pa
2
Hrs Pa
2
Secs
ISO Dose% (using ISO Criterion level)
ISO Proj Dose% (using ISO Criterion level)
Projected Exposure Points (using ISO Criterion level)
Exposure Points (using ISO Criterion level)
Exceedance time (LAS > Exceedance level)
*HML (LC-LA)
LCpk >135 (count) LCpk. >137 (count) LCpk. >140 (count)
LAFmx + Time LAFmin + Time
LASmx + Time LASmin + Time
LAImx + Time LAImin + Time
LAE
Cumulative Motion Index
Profile ‘Time-history’ Data Sets The following time-history data is saved at an interval
of once a second for every run and are available
following download:
LCpk LZpk
LAeq LCeq
LAvg (Q5, T=0) LAvg (Q3, T=0)
LAFmx LASmx
To Next Page
Loading...
Need help?
General
