EN-21
Note
• When a calibration time is reached, the watch will receive the calibration signal
only if it is in either the Timekeeping Mode or World Time Mode. Reception is not
performed if a calibration time is reached while you are configuring settings.
• Auto receive of the calibration signal is designed to be performed between midnight
and 5:00 a.m. , while you sleep (provided that the Timekeeping Mode time is set
correctly). Before going to bed for the night, remove the watch from your wrist, and
put it in a location where it can receive the signal easily.
• The watch receives the calibration signal for two to ten minutes everyday when
the time in the Timekeeping Mode reaches each of the calibration times. Avoid
performing any button operation within ten minutes before or after any one of the
calibration times. Doing so can interfere with correct calibration.
• Remember that reception of the calibration signal depends on the current time
in the Timekeeping Mode. The receive operation will be performed whenever the
display shows any one of the calibration times, regardless of whether or not the
displayed time actually is the correct time.
• Calibration signal reception is disabled while a countdown timer operation is in
progress.
To Next Page
Loading...
Need help?
General
