EN-31
Timer
You can set the countdown timer within a range of one
to 60 minutes. An alarm sounds when the countdown
reaches zero.
• All of the operations in this section are performed in
the Timer Mode, which you enter by pressing C (page
EN-6).
To set the countdown start time
1. While the countdown start time is on the display in the
Timer Mode, hold down A until the current countdown
start time starts to flash, which indicates the setting
screen.
• If the countdown start time is not displayed, use the procedure under “To use
the timer” to display it.
2. While a setting is flashing, use B (–) and D (+) to change it.
3. Press A to exit the setting screen.
Timekeeping Mode time
(Hour : Minutes Seconds)
SecondsMinutes
To Next Page
Loading...
