EN-32
To use the timer
Press D while in the Timer Mode to start the countdown timer.
• When the end of the countdown is reached, the alarm sounds for 10 seconds or
until you stop it by pressing any button. The countdown time is reset automatically
to its starting value after the alarm stops.
• Press D while a countdown operation is in progress to pause it. Press D again to
resume the countdown.
• To stop a countdown operation completely, first pause it (by pressing D), and then
press A. This returns the countdown time to its starting value.
• Calibration signal reception is disabled while a countdown timer operation is in
progress.
To Next Page
Loading...
Need help?
General
