2.
X
Hold down (C) for about 2 seconds.
This will cause the watch to enter the
Timekeeping Mode.
3.
X
Hold down (D) for about five seconds
until [Find] appears on the display.
When a connection is established
between the watch and phone, then the
phone’s ringtone will sound.
●
It will take a few seconds before the
phone tone sounds.
4.
X
Press any button besides (L) to stop the
tone.
●
You can press any watch button to stop
the phone tone only during the first 30
seconds after it starts to sound.
Configuring Watch Settings
You can use G-SHOCK Connected to specify
the amount of time until the Bluetooth
connection is automatically terminated and
the illumination duration, and to configure
other settings.
1.
Y
Tap the “G-SHOCK Connected” icon.
2.
X
Hold down (D) for about two seconds.
When a connection is established
between the watch and phone,
e
will stop
flashing.
Trying to connect Connection successful
3.
Y
Select the setting you want to change
and then perform the operation shown on
the phone screen.
Changing the Home City
Summer Time Setting
1.
Y
Tap the “G-SHOCK Connected” icon.
2.
X
Hold down (D) for about two seconds.
When a connection is established
between the watch and phone,
e
will stop
flashing.
Trying to connect Connection successful
3.
Y
Perform the operation shown on the
phone screen to change your Home City
summer time setting.
Pedometer
You can use the pedometer to keep track of
your step count while walking, engaging in
your normal daily activities, etc.
Counting Steps
If you are wearing the watch correctly, the
pedometer will count your steps as you walk
or engage in your normal daily activities.
Important!
●
Since this watch’s pedometer is a
wrist-worn device, it may detect non-
step movements and count them as
steps. Also, abnormal arm movements
while walking may cause a miss count
of steps.
Operation Guide 5554
8
To Next Page
Loading...
Need help?
General
