Q7
The hand and/or day indicator are not
aligned correctly.
Strong magnetism or impact can cause the
hands and/or the indicator to go out of
alignment. Correct hand and/or day indicator
alignment.
l
Correcting Hand and Day Indicator
Alignment
●
Check the information below to find out how
to align the hands and/or day indicator
manually.
l
Correcting Hand and Day Indicator
Alignment
Q8
The time setting is correct, but the
day indicator is between days.
Is the date setting being updated?
For information about how the day
changes, see the section below.
l
Hand and Day Indicator Movement
Other than the above.
The day indicator is not aligned correctly.
Correct day indicator alignment.
l
Correcting Hand and Day Indicator
Alignment
●
Check the information below to find out
how to align the hands and/or day
indicator manually.
l
Correcting Hand and Day Indicator
Alignment
Crown Operations
Q1
Nothing happens when I rotate the
crown.
If you do not perform any operation for about
two minutes after pulling out the crown
(approximately 30 minutes in the case of hand
and day indicator alignment), crown
operations will automatically become
disabled. Push the crown back in to its normal
position and then pull it out again to re-enable
crown operations.
l
Using the Crown
Q2
Crown operation does not work.
Crown operation is disabled while high-speed
hand movement is in progress after a watch
setting is changed, etc. Wait until the hands
stop moving before performing crown
operations.
Charging
Q1
The watch does not work even
though it is exposed to light.
The watch stops operating whenever the
battery goes dead. Keep the watch exposed
to light until it recharges sufficiently.
l
Charging
Other
Q1
I can’t find the information I need
here.
Visit the website below.
https://world.casio.com/support/
Watch Operation Guide 5719
27
To Previous Page
Loading...
Need help?
General
