Casio CDP-S160 User Manual

Configuring Settings
EN-18
■ To use a value to specify the transpose setting
• While the setting value is within the range of 0 to +12
semitones, you can use the procedure below to directly
input a desired setting value.
1. While holding down 3 FUNCTION, perform
steps (1) and (2) below.
(1) Press the TRANSPOSE– keyboard key (F5) or the
TRANSPOSE+ keyboard key (F{5).
(2) Use the [0] (E4) through [9] (C{5) keyboard keys to
input a two-digit transpose value.
For example, to specify a setting 8 semitones, press
keyboard keys in the following sequence: [0] (E4) 3
[8] (C5). Inputting the second and final digit will
cause a short and then long beep to sound,
indicating that the value you input was applied.
2. Release 3 FUNCTION.
The tuning feature specifies the frequency of the A4 note. You
can set a frequency within the range of 415.5 to 465.9 Hz. The
initial default setting is 440.0 Hz.
The setting you configure is retained even if you turn off the
Digital Piano.
Fine Tuning a Pitch (Tuning)
C1 C2 C3 C4 C5 C6 C7 C8
013578
246 9
[0] (E4) to [9] (C{5) keys
[+] key (E}4)
[–] key (D4)
TUNE– key (G5)
TUNE+ key (A}5)

Casio CDP-S160 Specifications

General

Keyboard	88 keys, Scaled Hammer Action Keyboard II
Touch Response	3 sensitivity levels, Off
Polyphony	64 notes
Tones	10 built-in tones
Effects	Reverb (4 types), Chorus (4 types)
Metronome	Yes
Demo Songs	2
Pedals	1 (sustain pedal included)
Amplifiers	8W + 8W
Power Consumption	8W
Weight	10.5 kg
Power Supply	DC 12V
Connectivity	USB Type-B, headphone jack, pedal jack
Transpose	-12 to +12 semitones
Tuning	A4 = 415.5 Hz to 465.9 Hz
Battery	6 AA batteries (approximately 13 hours of continuous operation)
Included Accessories	Music stand, AC adaptor
Dimensions	132.2 (W) x 23.2 (D) x 9.9 (H) cm (52 1/16 x 9 1/8 x 3 7/8 inch)