E-42
Assembling the Stand
1.
Orienting the pedal plug as shown in the
illustration, plug it into the pedal connector on
the bottom of the piano.
• Secure the pedal cord with the clip.
2.
Check to make sure that the POWER button
is in the OFF position (raised). If power is on,
press the POWER button to turn it off.
3.
Plug the power cord that comes with the
digital piano into the AC power jack on the
bottom of the digital piano.
*
* AP-500V only
IMPORTANT!
• The shape of the power cord plug and household power
outlet receptacle differ according to country and
geographical area. The illustration shows just one
example of the shapes that are available.
• The power cord of the AP-500 is hard-wired to the digital
piano.
4.
Plug the power cord into a household power
outlet.
CAUTION
• The screws of the stand can work loose due to the effects
of temperature and humidity changes, vibration, etc.
Because of this, you need to periodically check the
screws for proper tightness. Retighten any loose screws
you find.
• To power the digital piano, use a power outlet that
allows easy access when plugging in or unplugging the
power cord.
To connect cables
Clip
Pedal plug
Power Cord
Household power
outlet
AP500_e.book 42 ページ ２００６年１０月１９日 木曜日 午後３時５４分
To Next Page
Loading...
