Selecting and Playing a Tone
E-22
5.
When you are finished, press the R-15 (EXIT)
button twice.
• This will return to the screen that was displayed before
you displayed the scale screen.
• The root note setting you specify here is retained, even if
you later change to a different preset temperament.
1.
If required, perform the procedure under “To
select a preset scale” (page E-21) to select a
preset temperament.
2.
While holding down the R-13 (FUNCTION)
button, press the C-8 (SCALE) button to display
the scale screen.
3.
Use the R-17 (y) button to move the 0 to
“FineTune” and then press the R-16 (ENTER)
button.
• This displays the scale fine tuning screen like the one
shown below.
4.
You can adjust the tuning of each individual
note in the scale.
5.
When you are finished making adjustments,
press the R-15 (EXIT) button twice.
• This will return to the screen that was displayed before
you displayed the scale screen.
1.
While holding down the R-13 (FUNCTION)
button, press the C-8 (SCALE) button to display
the scale screen.
2.
Use the R-17 (i) button to move the 0 to
“AcmpScale”.
3.
Use the dial or the R-14 (–, +) buttons to change
the setting value.
4.
When the setting is the way you want, press the
R-15 (EXIT) button.
• This will return to the screen that was displayed before
you displayed the scale screen.
• The above scale on/off setting affects the Auto
Accompaniment bass part and Chord 1 through Chord 5
parts (A11 through A16). You also can turn scales settings
on or off for each individual part using the Part Parameter
(page E-43) “Scale (Part Scale Enable)” setting.
Fine Tuning a Scale
(1) Use the R-17 (t) button to move the 0 to “Note”, and
then use the dial or R-14 (–, +) buttons to select the
name of the note you want to fine tune.
• You can also press a keyboard key to specify a
note.
(2) Use the R-17 (y) button to move the 0 to “Cent”, and
then use the dial or R-14 (–, +) buttons to fine tune the
selected note. You can fine tune a note within the
range of –99 through +99 cents.
• Adjusting all of the notes in the scale to 0 changes
the selected tuning to equal temperament. The
C indicator will be on the display when any note
in the scale has a value other than 0.
Specifying whether the Current Scale
Settings Should be Applied to Auto
Accompaniment (Accomp Scale)
To do this: Select this setting:
Not apply scale settings to Auto
Accompaniment
oFF
Apply scale settings to Auto
Accompaniment
on
CTK7000_e.book 22 ページ ２０１０年７月２１日 水曜日 午後５時１５分
To Next Page
Loading...
