Using the Mixer
E-38
While the mixer screen is displayed, use sliders D-4 (1/9/EXT) to D-12 (MASTER) to change the displayed parameter settings. The
D-1 (PART/COMMON), D-2 (GROUP A/B) and D-3 (1-8/9-16) buttons are used to specify the parts that correspond to sliders
D-4 (1/9/EXT) to D-11 (8/16).
The following describes the operation of these buttons and sliders while the mixer screen is displayed.
● D-1 (PART/COMMON) button:
Each press toggles the mixer screen between master parameter settings (MASTER) and the settings of one of the part (A01
through A16, B01 through B16) parameters.
● D-2 (GROUP A/B) button:
Each press toggles the part parameter setting screen between one of the parts in group L (A01 through A16) and one of the
parts in group M (B01 through B16).
● D-3 (1-8/9-16) button:
Each press toggles the parts that correspond to parameter operations by sliders D-4 (1/9/EXT) to D-11 (8/6) between A01
through A08 (or B01 through B08) and A09 through A16 (or B09 through B16).
Using the Sliders to Change Parameter Settings
D-1 D-2 D-3 D-4 D-5 D-6 D-7 D-8 D-9 D-10 D-11 D-12
CTK7000_02_e.fm 38 ページ ２０１０年８月５日 木曜日 午後３時３９分
To Next Page
Loading...
