Saving Keyboard Setups to Registration Memory
E-49
1.
Press
bo
(RHYTHM).
2.
Configure the tone, rhythm, and other settings
you can to include in the setup.
3.
Press
bs
to select the bank you want.
Each press of
bs
cycles through the bank numbers.
• You also can select a bank by holding down
bs
as you
use the
br
(10-key) number buttons to enter a bank
number.
4.
While holding down
cn
, press a button from
bt
to
cm
to select an area.
This will save the settings you configured in step 2 into the
applicable setup.
• If there is anything already stored in the setup, it will be
replaced (deleted) by the new setup.
1.
Press
bs
to select the bank that contains the
setup you want to recall.
2.
Use buttons
bt
to
cm
to select the area whose
setup you want to recall.
This will recall the registration memory setup and
automatically configure the Digital Keyboard settings
accordingly.
• Notes currently being sounded by the keyboard may stop if
you recall a setup that causes a change in octave shift
(page E-18). To keep this from happening, either select a
setup that does not cause a change in the octave shift
setting, or hold down the pedal (which will cause notes
currently being played to be sustained).
■ Saving registration Data on an External Device
• Memory card (page E-59)
• Computer (page E-68)
To save a setup to registration
memory
Bank number
Bank 4
Store
Stored in Setup 4-1
To recall a setup from registration
memory
Bank 6
Reca l l
Setup 6-1 recalled
To Next Page
Loading...
