Casio DT-X5M10E - Page 46

No Operation Display Inspection contents
9
10
11
12
— 44 —
[Operation of the DT-X5]
Select "2.WLAN Tool".

Select "6.Config".

Select "1.IP Address".
Confirm the display on the left.
[Operation of the DT-X5]
1. Turn the DHCP off.
2. Set the IP Address.
IP:192.168.0.15
Subnet:255.255.255.0
[Operation of the DT-X5]
Push "CLR" key.
Select "1.OK".
[Operation of the DT-X5]
Select "4.Connection Net".
IP Address
1.Use DHCP: ON
2.IP address
[ ]
3.Subnet mask
[ ]
4.Default gateway
[ ]
IP Address
1.Use DHCP: OFF
2.IP address
[192.168.0.15]
3.Subnet mask
[255.255.255.0]
4.Default gateway
[ ]
Config
1.IP address
2.Name Server
3.Network config on
4.Connectable Net
5.Preferred Net
6.Network type net
7.Preferred-only on
8.Power Save on
Connectable net
1.Renew
2.Overseas
On the left IP Address is inputted.
Connectable access points are
displayed.
"Warning" is displayed.