101
Dynamic Photo
7. Use [8] and [2] to select “Number of Shots”, and then press [SET].
8. Use [8] and [2] to select either “1” or “2” and then press [SET].
9. First, shoot an image that includes the subject
you want to extract.
• Shoot an image in which the subject is as large as
possible. If you selected “2” for the “Number of Shots”
setting, the images should include some easily
identifiable reference point that you can use for later
alignment in step 10 below.
• If you selected “Moving Subject” the camera will record multiple subject
images. Do not move the camera until shooting is complete.
• If you selected “1” for the “Number of Shots” setting, this procedure is complete
with this step. The camera will extract the subject and display it on the monitor
screen. If you selected “Moving Subject” in step 6, the subject image will be
moving on the display.
• Even if you select “1” for the “Number of Shots” setting, certain conditions can
cause the setting to switch automatically to “2”.
• Flash is turned off automatically at this time.
To shoot under
these conditions:
Select
this
setting:
Notes:
The subject against a
complex background
2
You need to shoot twice to extract the
subject.
The subject against a
plain (no pattern)
background
1
You need to shoot only once to extract the
subject. If you select this setting, you will
not need to perform steps 10 and 11 of the
procedure below.
Text written on white
paper
Text See page 103.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
