37
Snapshot Tutorial
2. Use [4] and [6] to select the flash setting you want and then press
[SET].
• If there are no indicators on the monitor screen, you can cycle through the flash
modes by pressing [2] ( ). You can turn display information on or off by
pressing [8] (DISP) (page 11).
3. Slide the flash switch to open the flash unit.
4. Press the shutter button to shoot.
• For information about Flash Range, see page 127.
Setting
REC Screen
Icon Display
Description
Auto Flash None
Flash fires automatically in accordance with
exposure (amount of light and brightness)
conditions.
Flash Off Flash does not fire.
Flash On
Flash always fires. This setting can be used to
brighten a subject that normally comes out dark
due to daylight or backlight (daylight synchro
flash).
Red Eye
Reduction
Flash fires automatically. This type of flash can be
used to reduce the chance of redness in the
subject’s eyes.
Back lamp
Flashes orange while the flash is charging to
indicate that image recording is disabled.
• You will not be able to take another flash
snapshot until the lamp stops flashing
orange, which indicates that charging is
complete.
< indicates the flash will fire.
To Next Page
Loading...
Need help?
General
