14
Quick Start Basics
To replace the battery
1. Open the battery cover and
remove the current battery.
2. Load a new battery.
You can use either of the two following methods to charge the camera’s battery.
• USB-AC adaptor
• USB connection to a computer
. To charge with the USB-AC adaptor
The adaptor lets you charge the battery while it is loaded in the camera.
While the camera is turned off, connect in the sequence shown below (
1
,
2
,
3
,
4
).
Charging time: Approximately 120 minutes
Charge the Battery
Stopper
4
3
2
1
USB cable
(included with camera)
Making sure that the mark on the USB cable connector is
towards the monitor screen side, connect the cable to the camera.
[USB/AV] port
USB-AC adaptor
Power cord
To Next Page
Loading...
Need help?
General
