15
Quick Start Basics
IMPORTANT!
• Make sure that you insert the cable connector into the USB/
AV port until you feel it click securely into place. Failure to
insert the connector fully can result in poor communication or
malfunction.
• Note that even while the connector is fully inserted, you still
will be able to see the metal part of the connector as shown in
the illustration.
Back Lamp Operation
. To charge using a USB connection to a computer
USB connection lets you
charge the battery while it is
loaded in the camera.
While the camera is turned off,
connect in the sequence
shown below (
1
,
2
). If the
camera is on, press [ON/OFF]
(Power) to turn it off before
connecting it to your computer.
Charging time: Approximately
140 minutes
Lamp Status Description
Lit Red Charging
Flashing Red
Abnormal ambient temperature, USB-
AC adaptor problem, or battery
problem (page 113)
Off Charging complete
Back lamp
USB
2
1
USB cable
(included with camera)
Making sure that the mark on the USB cable
connector is towards the monitor screen side, connect
the cable to the camera.
[USB/AV] port
USB port
Computer
(power turned on)
To Next Page
Loading...
Need help?
General
