APPENDIX
109
Color of the playback image
is different from the image
on the monitor screen dur-
ing recording.
Images are not displayed.
Cannot playback audio,
cannot hear audio, or can-
not control the audio play-
back using the remote con-
troller.
Playback time is short.
Position the camera so sunlight does not shine di-
rectly into the lens.
This camera cannot display non-DCF images re-
corded onto a memory card using another digital
camera.
1) Align the mode selector with “AUDIO”.
2) Transfer MP3 files to the camera’s AUDIO folder.
3) Correctly connect the headphones to the head-
phones jack.
4) Adjust the volume to a higher level.
5) Charge the battery (page 24).
6) Slide the remote controller lock switch in the op-
posite direction of the arrow marking to unlock
the controls.
7) Check the files you are trying to play (page 94).
8) Check to make sure the PLAYLIST.TXT file lists
the MP3 files you want to play.
Charge the battery (page 24).
Sunlight or light from another source is shining di-
rectly into the lens during recording.
A memory card with non-DCF images recorded
with another camera is loaded in the camera.
1) Mode selector is set to “REC” or “PLAY”.
2) There is no MP3 file data in memory. This is indi-
cated by the message “No Data!” on the remote
controller LCD.
3) Stereo headphones are not connected correctly.
4) Volume setting is too low.
5) The battery is dead.
6) The remote controller buttons are locked.
7) There are no playable files.
8) Improper PLAYLIST.TXT file contents
The battery is dead.
Playback
Audio Playback
Symptom Possible Cause Action
* Note that audio player capabilities are available with the EX-M1 only.
To Next Page
Loading...
Need help?
General
