67
OTHER RECORDING FUNCTIONS
NOTE
• The initial default setting is “REC Mode”.
When you want to assign this function to
[왗] and [왘] keys:
Recording mode
•[왗] and [왘] cycle through recording
modes: Snapshot, Best Shot, Movie
(page 142).
Flash mode
•[왗] and [왘] cycle through the flash
mode settings (page 45).
EV shift
•[왗] decreases compensation, [왘]
increases compensation (page 51).
White balance setting
•[왗] and [왘] cycle through white
balance settings (page 52).
ISO sensitivity
•[왗] and [왘] cycle through sensitivity
settings (page 65).
No function assigned
Select this:
REC Mode
Flash
EV Shift
White Balance
ISO
Off
Assigning Functions to the [왖] and [왔]
Keys
A “key customization” feature lets you configure the [왖]
and [왔] keys so they change camera settings whenever
they are pressed in the REC mode. After you configure the
[왖] and [왔] keys, you can change the setting assigned to
them without going through the menu screen.
1.
In the REC mode, press [MENU].
2.
Select the “REC” tab, select “U/D Key”, and
then press [왘].
3.
Use [왖] and [왔] to select the setting you
want, and then press [SET].
To Next Page
Loading...
