39
Snapshot Tutorial
IMPORTANT!
• If there is not enough available capacity on the memory card, you may not be able
to record the number of CS images indicated on the monitor screen. Make sure
your memory card has sufficient remaining capacity before shooting with using
continuous shutter.
• With continuous shutter, exposure and focus for the first image are applied for
successive images as well.
• When using a continuous shutter mode, keep the camera still until shooting is
finished.
• Continuous shutter cannot be used in combination with any of the following.
– Some BEST SHOT scenes (AUTO BEST SHOT, Dynamic Photo, Multi-motion
Image, ID Photo, Business cards and documents, White board, etc., Prerecord
(Movie), For YouTube, Voice Recording)
– easy Mode
– Movie Recording
– Make-up
• The speed of “CS: Normal Speed CS” depends on the type of memory card loaded
in the camera and the amount of free space available for storage. When shooting
to built-in memory, continuous shutter shooting is relatively slow.
• “CS: Normal Speed CS” speed is slower when shooting with flash.
• You cannot use the self-timer in combination with “CS: Normal Speed CS”,
“CS: High Speed CS”.
• Note that images recorded with “CS: High Speed CS” and “CS: Flash” are of
somewhat lower resolution and more prone to digital noise than images recorded
with “CS: Normal Speed CS”.
• The ISO sensitivity setting always is “AUTO” for “CS: High Speed CS” and
“CS: Flash”, regardless of the camera’s current ISO sensitivity setting.
• The flash range for Flash CS is narrower than that for normal flash.
• Shooting a very bright subject can cause a vertical band or a pink cast on the
monitor screen image. This does not indicate malfunction.
To Next Page
Loading...
Need help?
General
