Example 5: To use the paired-variable data input in Example 4 (page 61)
and display the results of the two regression calculations shown below
• The regression equation "y = a + bx" coefficients (a, b), and the
correlation coefficient (r) when linear regression is performed on the
data
• The regression equation "y = a + bx + cx
2
" coefficients (a, b, c) when
quadratic regression is performed on the data
Note
• For information about regression calculation types supported by the Statistics app, see
the "Supported Regression Type List" (page 64).
1. Perform steps 1 through 5 of the procedure under Example 4 (page
61).
2. Select [Reg Results], and then press
.
• This displays the regression type menu.
3. Select [y=a+bx], and then press .
• This displays the linear regression Reg Results screen.
4. Press or to return to the Statistics Editor.
5. Press , and then select [Reg Results] > [y=a+bx+cx
2
].
• This displays quadratic regression Reg Results screen.
6. Press or to return to the Statistics Editor.
•
For the meanings of the variables shown on the Reg Results
screen, see the "List of Statistical Value Variables and Statistical
Calculation Functions" (page 67).
63
To Next Page
Loading...
Need help?
General
