Stopwatch
The stopwatch measures elapsed time in
1/100-second units for the first hour, and in 1-
second units after that for up to 24 hours.
It can also measure split times.
Measuring Elapsed Time
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
2.
Use the operations below to measure
elapsed time.
After first hour
Hour, minute, secondMinutes, seconds,
1/100 seconds
First hour
3.
Press (C) to reset the elapsed time to all
zeroes.
Measuring a Split Time
1.
Enter the Stopwatch Mode.
l
Navigating Between Modes
2.
Use the operations below to measure
elapsed time.
A
C
C
A
Stop
Split release
Split
Start
After first hour
Hour, minute, secondMinutes, seconds,
1/100 seconds
First hour
3.
Press (C) to reset the elapsed time to all
zeroes.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper will not sound if battery power
is low.
Setting the Timer Start Time
The countdown start time can be set in 1-
minute units up to 24 hours.
1.
Enter the Timer Mode.
l
Navigating Between Modes
2.
Hold down (D) for at least two seconds.
Release the button when the minutes
digits start to flash.
This causes the minutes digits to flash.
3.
Use (A) and (C) to change the timer
minutes setting.
4.
Press (E).
This causes the hours digit to flash.
5.
Use (A) and (C) to change the timer hours
setting.
6.
Press (D) to exit the setting screen.
Note
●
You can also use G-SHOCK
Connected to configure timer settings.
Operation Guide 5594
28
To Next Page
Loading...
Need help?
General
