1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (D) to scroll through the alarm ([AL1]
to [AL4], [SNZ]) and hourly time signal
([SIG]) screens until the one you want to
turn off is displayed.
Alarm number or hourly time signal
3. Press (A) to turn off the displayed alarm or
the hourly time signal.
●
Each press of (A) toggles between on
and off.
●
Turning off all alarms will cause [ALM]
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
Note
●
If [ALM] (alarm) is still displayed, it
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Stopwatch
The stopwatch measures elapsed time in units
of 1/1000 second up to 99 hours, 59 minutes,
59.999 seconds (100 hours).
When this maximum limit is exceeded,
elapsed time measurement returns to 0, and
timing continues from there.
You need to specify a distance before you can
perform speed measurements. If 0.0 is
specified as the distance, 0 will be displayed
for the speed.
Split Times and Lap Times
●
Split time
A split time is the time elapsed from the start,
up to any point along the course of an event.
D
A
A
D
Goal
Split 3
Split 2
Split 1
Start
●
Lap time
A lap time shows the time elapsed during a
specific lap around a track, etc.
D
A
A
D
Goal
Lap 3
Lap 2
Lap 1
Start
Measuring Elapsed Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
Minutes
Seconds
Hours 1/1000 seconds
2. Use the operations below to measure
elapsed time.
Note
●
The speed hand moves each time you
stop a measurement operation. Wait
until the hand stops moving before
performing button operations.
3. Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 5715
11
To Next Page
Loading...
