Navigating Between Modes
Each press of (C) cycles between watch
modes.
C
C
C
CC
Alarm Mode
Stopwatch Mode
Timekeeping Mode
World Time Mode Timer Mode
Cycling Between
Timekeeping Mode Digital
Display Contents
Each press of (D) in the Timekeeping Mode
cycles the display information as shown
below.
Hours, minutesMonth, day
Seconds Seconds
Viewing the Face in the Dark
The watch has an LED light that you can turn
on for reading in the dark.
●
To illuminate the face manually
Press (B) to illuminate the face and digital
display.
●
Illumination will turn off automatically if an
alarm starts to sound.
●
To illuminate the face when Auto Light
is enabled
If Auto Light is enabled, face illumination will
turn on automatically whenever the watch is
positioned at an angle of 40 degrees or more.
Important!
●
Auto Light may not operate properly
when the watch is at a horizontal angle
of 15 degrees or greater from
horizontal as shown in the illustration
below.
●
Electro-static charge or magnetism
can interfere with proper auto light
operation. If this happens, try lowering
your arm and then angle it towards
your face again.
●
When moving the watch you may note
a slight rattling sound. This is due to
operation of the auto light switch,
which determines the current
orientation of the watch. It does not
indicate malfunction.
Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
●
Configuring the Auto Light Setting
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least three seconds
to toggle Auto Light between enabled and
disabled.
●
[A.LIGHT] is displayed while Auto Light
is enabled.
Note
●
If you do not disable it manually, Auto
Light remains enabled for
approximately six hours. After that, it
becomes disabled automatically.
Watch Operation Guide 5715
6
To Next Page
Loading...
