●
Specifying the Illumination Duration
You can select either 1.5 seconds or three
seconds as the illumination duration.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least three seconds.
Release the button when the city code
starts to flash.
3. Press (C) nine times.
[LT] appears on the display with [1] or [3]
flashing.
4. Press (D) to select an illumination
duration.
[LT1]: 1.5-second light
[LT3]: 3-second light
5. Press (A) to complete the setting
operation.
Note
●
If you do not perform any operation for
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the
Timekeeping Mode.
Time Adjustment
Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures below to adjust the
current date and time settings, and to select a
Home City.
●
Setting a Home City
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
configure a summer time setting.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least three seconds.
Release the button when the city code
starts to flash.
3. Use (B) and (D) to change the Home City
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
●
For details refer to the information
below.
l
City Table
4. Press (C).
5. Use (D) to change the summer time
setting.
●
[OFF]
The watch always indicates standard
time.
●
[On]
The watch always indicates summer
time.
6. Press (A) to complete the setting
operation.
Note
●
If you do not perform any operation for
two or three minutes while the setting
screen is displayed, the watch
automatically returns to the
Timekeeping Mode.
●
Setting the Time/Date
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least three seconds.
Release the button when the city code
starts to flash.
Watch Operation Guide 5715
7
To Next Page
Loading...
