Casio Geometry User Manual

20060601
2-13
Drawing and Editing Objects
2. Perform the following operation: 4(Construct) – 6:Parallel.
• This will draw a parallel to the selected line segment that passes through the selected
point.
Note
You can perform a parallel construct operation while any of the following combination objects
is selected.
• A single line segment and a single point, a single line and a single point, a single ray and a
single point, a single vector and a single point
• One side of a polygon and a single point
u To construct a tangent
1. Draw a circle.
2. Perform the following operation: 4(Construct) – 7:Tangent.
• This will cause the message “Select Curve” to appear.
3. Move the pointer close to the location on the circle where you want to construct the
tangent.
• Move the pointer towards the circle until  marks appear on it.
4. Press w.
• This will draw a line that is tangent to the circle at the location you selected with the
pointer.
Note
You can perform the tangent construct operation while a circle or arc is selected.

Casio Geometry Specifications

General

Brand	Casio
Model	Geometry
Category	Software
Language	English