Casio Geometry

20060601
6-1
Working with Animations
6. Working with Animations
An animation consists of one or more point/curve pairs, in which the curve can be a line
segment, circle, or arc. You build an animation by selecting a point/curve pair and then
adding it to an animation.
Creating and Running an Animation
u To add an animation and run it
Example: To animate a point around a circle
1. Plot a point and draw a circle, and select them.
2. Perform the following operation: 6(Animate) – 1:Add Animation.
• This will add an animation effect that causes a point to move along the circumference of
the circle.
3. Perform either of the following operations: 6(Animate) – 5:Go (once) or
6(Animate) – 6:Go (repeat).
• This cause the point to move along the circumference of the circle.
4. To stop the animation, press J or o.
/
...
/
...