English
Controlling the Keyboard Sounds
E-13
4.
Press
4
and immediately release it.
This enters record standby.
5.
Output the sound in the direction of the
microphone.
The Digital Keyboard will start sampling automatically,
and stop after one second.
• Sampling will not start if the volume of the sound picked
up by the microphone is too low.
• What you sample is stored as tone number 401.
6.
Try playing something on the keyboard.
• You can press pad 4 or 5 (
ck
or
cl
) to sound the
sampled sound (page E-8).
• A new sample replaces sample data currently assigned to
tone number 401. All of the old data (including short
sampled sounds) is deleted.
■ Short Sampling
With short sampling, you can sample up to three sounds,
each one with a duration of approximately 0.3 seconds. You
can sound the short sampled sounds using voice pads
1 through 3.
1.
Connect a microphone to the Digital Keyboard.
Refer to steps 1 through 2 under “Full Sampling” (page
E-12).
2.
While holding down
4
, press the voice pad
(
br
,
bs
, or
bt
) that corresponds to the tone
number where you want to store the sound.
• The relationship between tone numbers and voice pads
is shown below.
Example: When voice pad 3 (Tone Number 404) is
selected
Record standby is entered when you release
4
.
Flashes
W
aiting
Flashes
Lights
Samp l i ng
Original
Selected Tone
Number
402 403 404
Pressed Voice Pad
Pad 1
(
br
)
Pad 2
(
bs
)
Pad 3
(
bt
)
Vo i . Pad3
Flashes
W
aiting
Flashes
To Next Page
Loading...
