Controlling the Keyboard Sounds
E-14
3.
Output the sound in the direction of the
microphone.
Sampling starts automatically and stops after about 0.3
seconds.
• Sampling will not start if the volume of the sound picked
up by the microphone is too low.
4.
Try playing something on the keyboard.
• You also can sound the sampled sound by pressing the
voice pad you pressed in step 2.
• Sampling a new sound deletes the sound assigned to the
same tone number and the full sampling sound (page
E-12).
Turning off power will causes all sampled sound data to be
deleted.
■ How sampled sounds are played
Pressing Middle C (C4) will play back the original sound. The
keys to the left and right of C4 play the sound at different
pitches.
Set 1 of voice pads 1 through 4 (
br
through
ck
) produce
sampled sounds without modification.
1.
Press
3
(FUNCTION) a number of times until
“SmplAuto” appears on the display (page E-4).
2.
Press
bq
(10-key) [–] key to select the OFF
setting.
This enables manual sampling. When this setting is
selected, sampling starts as soon as you release
4
in
step 4 under “Full Sampling” (page E-12) or step 2 under
“Short Sampling” (page E-13).
• When the above setting is “oFF”, sampling starts when
you release
4
, not when you press it. Sampling will
not start if you keep
4
depressed.
Vo i . Pad3
Lights
Turning off power clears sampled data!
Starting a Sampling Operation Manually
C4
Smp l Au t o
To Next Page
Loading...
Need help?
General
